A tire-pressure gauge is a pressure gauge used to measure the pressure of tires on a vehicle.
Since tires are rated for specific loads at certain pressure, it is important to keep the pressure of the tire at the optimal amount. Tires are rated for their optimal pressure when cold, meaning before the tire has been driven on for the day and allowed to heat up, which ultimately changes the internal pressure of the tire due to the expansion of gases. The accuracy of a typical mechanical gauge as shown is ±3 psi (21 kPa). Higher accuracy gauges with ±1 psi (6.9 kPa) accuracy can also be obtained.
Many modern cars now come with built-in tire pressure sensors that allow all four tire pressures to be read simultaneously from inside the car. In 2005, most on-board TPMS used indirect pressure monitoring. The anti-lock brake sensors detect one tire rotating faster than the rest and indicate a low tire pressure to the driver. The problem with this method was that if tires all lost the same pressure then none would show up against the others to indicate a problem.
Since September 2007 all new automobiles below 10,000 lb (4,500 kg) in weight sold in the United States are required to incorporate a Tire Pressure Monitoring System (TPMS), which is capable of monitoring all four tires and simultaneously reporting under-inflation of 25 percent of cold placard pressures in any combination of all four tires. TPMS known as Direct TPMS are capable of TREAD Act legislation requiring simultaneous pressure measurement for each tire pressure.[1]
Early TPMS sensors required batteries but the latest TPMS technology eliminates all sensor batteries.[2]